It staggered the busy season of spring seedlings and afforestation(5 gallon plant pots), and arranged the seedlings in the relatively idle summer season, and had sufficient time for homework. Therefore, the summer cuttings of sweet-scented osmanthus flowers have high efficiency in production. Once again, the annual osmanthus flowering season, a burst of sweet-scented osmanthus floating into the nose, really refreshing, intoxicating(plastic nursery pots). Osmanthus fragrans reproduction mainly consists of cuttings, which has the advantages of short seedling period, fast growth after survival, early flowering and so on.
(black 20 gallon plastic container wholesale)For those who like to cut flowers, the reproduction of sweet-scented osmanthus is mainly based on cuttings(15 gallon plant pots). After survival, it grows faster and blooms very early. Here is a recommended method for cutting osmanthus flowers. The following is a brief introduction to the technique of osmanthus cuttings: osmanthus sinensis has two stages: summer insertion (early from early May to early June) and autumn insertion (from August to September). When the summer shoots are lignified or semi-lignified(20 gallon plant pots). Semi-lignified branches are also called cuttings or green branches.
The substrate is preferably a slightly acidic sandy loam(7 gallon plant pots), light loam or river sand and peat, and is made into a 1-meter wide bed. Irrigation with 40% formaldehyde 50 times solution or 0.1% potassium permanganate solution to kill the bacteria. The cuttings are selected from 10 to 15 years old mother trees without disease and insects. The middle and upper parts of the canopy are cut into the woody or semi-woody strong branches(black plastic nursery pots). The cuts are about 10 cm long, with 3 buds, 1 pair of leaves at the top, and the lower end. 0.5 cm oblique cut under the section.
(black 20 gallon plastic container wholesale)For disinfection, it is best to follow the cut(3 gallon nursery pots). If the cuttings are cut from the field, they must be kept in a cool place, and the leaves should be sprayed with water to keep them moist and prevent the cuttings from evaporating and losing water. This is the key to ensuring survival. In order to promote rooting and increase the survival rate of cuttings, the roots of the cuttings were treated with 200 to 300 ppm of neva acetic acid or ABT rooting powder for 3 to 5 minutes to stimulate rooting(seedling trays). Before inserting, insert the bed to pour water (but not water), the row spacing is 5 to 10 cm.
Two-thirds of the cuttings are placed in the soil, leaving one bud on the ground. After pouring, pour water and keep it moist(2 gallon nursery pots). After the insertion, the shade shed is used, and the closed type is adopted to maintain the transmittance of about 30% in the shed. The temperature is controlled between 25 ° C and 27 ° C, and the relative humidity of the air is above 80%, and the air is ventilated once a day. Watering properly, but the water must be strictly prevented to prevent the cuttings from rot(plastic nursery pots manufacturers). The soil of the insertion bed is kept moist and well ventilated to facilitate rooting.(black 20 gallon plastic container wholesale)
There are many varieties of flowers, such as Dangui(1 gallon nursery pots), Four Seasons Osmanthus, Late Silver and so on. Semi-lignified branches, cut into 10-12 cm long, cut into a horseshoe shape at the lower end and 2-3 leaves at the upper end. It is advisable to use humus-rich acid soil or sandy loam soil, preferably with vermiculite as the matrix. Because the vermiculite texture is loose and breathable, the heat preservation and moisturizing performance is good(wholesale nursery pots). Because it is mineral, it is treated by high temperature, no pathogen, and is good for cutting. Rooted to survive.