Moreover, the fertilization selection for potted trees is generally carried out during the growth period(72 cell propagation trays wholesale), and we can keep it once every 2-3 weeks, probably during the period from April to September. If the rich tree grows too weak due to lack of fertilizer, the frequency of fertilization can be increased appropriately(black plastic plant pots), so that the purpose can be achieved to ensure that the plant can maintain a strong growth condition with sufficient nutrients.
Bulk Buy Small Black 3.5 Inch Plant Pots MOQ:1000pcs! 19 Years Experience plastic Plant Pots Manufacturer, 35,000m² Workshop Area, Serving 3,000+ Customers!
At this time, we need to loosen the grafted parts in time(square nursery pots), and if necessary, we should also remove the plastic strips in time to avoid affecting the germination and growth of the grafted seedlings. In this case, the grafting of the rich tree, while using the rich tree of the rich tree as the rootstock, then cut off the upper trunk of the plant from a position about 40 cm from the ground(flat plastic tray). Then, at the lower end of the section, 1-2 cm, the knife is made to make a marriage interface.(bulk buy small black 3.5 inch plant pots)
Note that the length of the slanting opening is as consistent as possible with the chamfered surface of the scion(seed starter trays). Sometimes it is inevitable that the incision of the rootstock is larger than the wedge-shaped opening of the scion, so that the scion can be moved to one side, and the formation layer of the rootstock is brought into close contact with the formation layer of the scion as much as possible(2 gallon plant pots supplier), which is more conducive to the germination and survival of the grafted seedling.
The tapered end of the prepared scion is evenly inserted into the incision of the rootstock so that the wedge-shaped opening of the scion is sufficiently fitted to the incision of the rootstock(propagation tray). Of course, we usually bury the right amount of particles in the potting soil. As long as you can grasp the details, there is generally no difference(2 gallon plant pots wholesale). You may wish to try more, after all, practice makes perfect. If it goes well, we can see the scion sprouting in about 1 month.
(bulk buy small black 3.5 inch plant pots)Use a sharp edge to cut the inside of the trunk longitudinally until it is visible(plastic nursery pots wholesale). It is also necessary to use a plastic film to entangle the grafted parts. This step is also very important. The purpose is to make the rootstock incision of the graft interface more fully and tightly contact with the scion incision(nursery plant pots), and it will not easily loosen. It can also prevent rainwater and dew from infiltrating the graft interface and infecting the bacteria.
Therefore, the grafting process of the fortune tree is completed(15 gallon nursery pots wholesale). If the main work of grafting is completed, at this point, what needs to be done later is the maintenance management work. As for the growth of grafted seedlings in the late stage, it is mainly based on whether there is a direct link between the maintenance management work in the later stage(greenhouse supplies pots). The grafting process of the rich tree is the same as that of many other tree species.
Soybeans contain a lot of nitrogen, and when cooked, the fertilizer can be used to supplement the nutrients and produce no odor(seed starting trays). It will not form an odor in the indoor air environment. The application amount is a little less, and it will not cause obvious damage to the potted plants. It is safer when the fertilizer is used(plastic grow pots). In addition to the selection of suitable fertilizers for potted trees, the timing and method of fertilization is also important.(bulk buy small black 3.5 inch plant pots)